![]() If you wish to reactivate the lock feature, press and hold the LOCK button again for 2 seconds. If the light is blinking, push the LOCK button to turn off the lock feature: Press and hold the LOCK button for 2 seconds, then the LED will glow solid indicating the lock feature has been deactivated. 377LM,940D,139.53754 Wireless Keypad Keyless Entry only for a Purple Learn Button of Liftmaster/Sears Craftsman/Chamberlain Garage Door Openers(1Pack) 4.4 out of 5 stars 294 19.55 19. To deactivate this feature: Check for a blinking light on the multi-function door control panel. The door will, however, open and close by activating the push bar, key switch or keypad. With the LOCK button activated, the receiver logic board will NOT accept signals from the remote control. With this feature the indicator light behind the push bar will flash when the lock switch is turned ON and when you press the remote control the light bulb on the opener will flash two times. ![]() The red LED will blink once and then turn off. The Multi-Function Door Control Panel includes a LOCK button. Programming Instructions for the GWKP Genie garage door opener keyless entry involve involving the two sets of steps below: To erase the old PIN (personal identification number) press and hold down, in order, the PROG, 6 and Up/Down Arrow keys.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |